External Joint Pin

Board Stage Brackets / hopups fit into the (V) pressing of the standard which is nearest to the wall. The 2 & 3 BSB have holes into which tie bar pins are attached. They are used to provide cantilevered platform on the inside of the scaffold nearest the wall.

The first step onto a stair access or ladder access is always difficult due to site constraints, ground levels and base outs. The use of the adjustable step down bracket gives the comfort of adjustment to balance the variables so the step becomesbalanced when getting on or getting off a stair access at ground level.

Standards are vertical structural member of the scaffold system which are made from 48.3 OD X 4mm Tubes. Standards have ÒVÓ pressings in clusters at 495 mm centres, which provide location points for Transoms, Ledgers, Braces,, Hopups etc and a spigot fixed at the top

Adjustable base jack enables accurate levelling of the scaffolding on uneven ground and infinite adjustment on sloping ground

Heavy duty back to back angle transoms for location of scaffold boards. These are used to where greater loads are required for pedestrain access.